Crawl Space Encapsulation

Before	After

Our Crew installed CleanSpace to encapsulate this crawl space for a homeowner, located in Highlands, NC. 

Crawl Space Encapsulation in Highlands, NC

Before	After

This crawlspace was a dark and scary area when this homeowner first called All-Dry of the Carolinas. They had already tried to have a crawlspace liner installed in their crawlspace, but it just wasn't doing the job for them. These DIY crawl space solutions generally do not work very well because of a few reasons; they are not thick enough, and they usually aren't sealed correctly. This is important because if the area isn't sealed properly, then the water vapor is still able to get into the crawlspace and cause problems.

The "before" photo is how the crawl space looked when our System Design Specialist first inspected the home. Before the work was done, the crawlspace was a dark, scary area that had been trashed. The black liner absorbs most of the light and makes the crawl space much darker. There is also dirt and debris all throughout the crawlspace, caused by water intrusion, unsealed vents, and other issues.

The "after" photo shows a much different story, the CleanSpace Liner makes a huge difference in this space. First off, you can actually see under the house! The white liner does a great job at reflecting most of the light, which brightens the space. This makes it easier to see, work, and move under a home! Those are just the visual benefits of the product! What CleanSpace really does is keeps the water vapor from getting into the crawlspace. One way is by its thickness, it is a 20 mm thick liner, which does an excellent job of keeping the moisture out. Another way is through the sealing of the CleanSpace liner to the wall, this is extra important because those are really the only areas where moisture can come through.

Foundation Repair in Highlands, NC

Before	After

If you've looked at any other content on our site, you may have seen wall anchors in action. This before and after is going to be a little different than some of the others. This is going to look at more of the cleanup, then the installation of the wall anchors. For this particular project, we had the crew had to install three wall anchors under the garage floor.

The "before" picture shows what it looked like once the crew had cut out the sections for the wall anchors to be installed, and had already excavated the dirt down to the level needed to install the wall anchor. As you can see, this can be a very messy process, especially in a garage. We always do our best to keep wherever we are working clean (as we can), and always clean-up after ourselves! In this garage, there was a tarp laid out to hold as much of the dirt as possible, to keep the floor from getting too dirty.

The "after" picture is a much different story than from before. The biggest difference is the fact there aren't deep holes in the middle of the garage or a huge pile of dirt. Jokes aside, our crew filled the holes back with the dirt, then poured some new concrete back into the holes. Although there will be a few "discolored" areas in this garage, it is all worth it in the end. First off, the only other option would be to rip up the garage floor and completely replace it, and two; the cuts must be made so that the outside wall doesn't get any worse.