Foundation Repair in Highlands, NC

If you've looked at any other content on our site, you may have seen wall anchors in action. This before and after is going to be a little different than some of the others. This is going to look at more of the cleanup, then the installation of the wall anchors. For this particular project, we had the crew had to install three wall anchors under the garage floor.

The "before" picture shows what it looked like once the crew had cut out the sections for the wall anchors to be installed, and had already excavated the dirt down to the level needed to install the wall anchor. As you can see, this can be a very messy process, especially in a garage. We always do our best to keep wherever we are working clean (as we can), and always clean-up after ourselves! In this garage, there was a tarp laid out to hold as much of the dirt as possible, to keep the floor from getting too dirty.

The "after" picture is a much different story than from before. The biggest difference is the fact there aren't deep holes in the middle of the garage or a huge pile of dirt. Jokes aside, our crew filled the holes back with the dirt, then poured some new concrete back into the holes. Although there will be a few "discolored" areas in this garage, it is all worth it in the end. First off, the only other option would be to rip up the garage floor and completely replace it, and two; the cuts must be made so that the outside wall doesn't get any worse.